Agri-Fab 45-0381 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Agri-Fab 45-0381에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agri-Fab 45-0381 13 페이지. 3-point aerator
페이지 인쇄4. Attach the weight bracket to the tray using a 3/8" x 1"
bolt (H) and 3/8" nylock nut (I). Do not tighten yet. See
figure 4.
5. Assemble the straps to the holes in the weight bracket
and the tray that are aligned. Use two 1/2" x 2-1/4" bolts
(B), .75" spacers (O) and 1/2" nylock nuts (J). Do not
tighten yet. See figure 4.
O
B
STRAP
6. Attach the mast extension straps to the front of the tray
using two 1/2" x 1-1/4" bolts (C) and 1/2" nylock nuts
(J). Do not tighten yet. See figure 5.
7. Assemble the mast sides to the straps using the 1-1/2"
spacer (P), 1/2" x 3-1/2" hex bolt (A) and 1/2" nylock
nut (J). Do not tighten yet. See figure 5.
8. Tighten all loose nuts assembled through step 7.
P
J
MAST
SIDE
H
WEIGHT
BRACKET
I
J
STRAP
C
A
J
MAST
EXTENSION
STRAP
9. Attach the four axle support brackets to the tray using
eight 3/8" x 1" hex bolts (H) and 3/8" nylock nuts (I). Do
not tighten yet! See figure 6.
4
10. Secure the axles to axle support brackets using two
washers (K) and 1/8" x 1-1/2" cotter pins (L) at the ends
of each axle. See figure 7.
11. Tighten the four axle brackets assembled in step 10.
See figure 7.
12. Add grease to the spool assemblies through the grease
fittings until grease is forced out the ends of the spool
tubes. See figure 7.
5
5
H
K
L
6
AXLE
SUPPORT
BRACKETS
I
7
GREASE
FITTING