Australian Warning Systems 4200 Series 설치 및 작동 지침
{카테고리_이름} Australian Warning Systems 4200 Series에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Australian Warning Systems 4200 Series 2 페이지. 4200 series led dash lights
페이지 인쇄Australian Warning Systems 4200 series LED lights are compact and versatile
high intensity directional LED warning lights suitable for mounting against front
or rear windscreens inside a vehicle. Colourless until illuminated, these discrete
LED lights offer self contained electronics and feature packed controls.
Additional benefits of Australian Warning Systems LED lights include low
current draw, a long and maintenance free service life with reliable solid-state
operation and extremely low electromagnetic emissions. The LED lights are
dual voltage (12-24 VDC), and simply plug into the vehicle's existing cigarette
lighter or accessory socket. Alternatively, the plug can be removed and the unit
hardwired through a switch.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install or operate this product unless you have read & understood the safety information contained below.
Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are
1.
essential to ensure the safety of you and those you are seeking to protect.
Exercise caution when working with live electrical connections.
2.
This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
3.
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
Proper placement and installation are vital to the performance of this warning device. Install this product so that output
4.
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he
can operate the system without losing eye contact with the roadway.
Do not install this product or route any wires in the deployment area of an air bag. Equipment mounted or located in an air
5.
bag deployment area may reduce the effectiveness of the air bag or become a projectile that could cause serious personal
injury or death. Refer to the vehicle owner's manual for the air bag deployment area. It is the responsibility of the
user/operator to determine a suitable mounting location ensuring the safety of all passengers inside the vehicle.
It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
6.
vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles or other obstructions.
The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
7.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, or walking on or around traffic lanes.
This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all
8.
laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and
regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
Specifications
:
Voltage: 12-24VDC
Current: 0.5 amps @ 12VDC
0.25 amps @ 24VDC
Flash Patterns: 30
Light Source: 8 x 1 watt LED's
Australian Warning Systems
Installation and Operation Instructions
4200 Series LED Dash Lights
Page 1