4SeasonSpa Augusta 20 사용자 설명서 - 페이지 9
{카테고리_이름} 4SeasonSpa Augusta 20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4SeasonSpa Augusta 20 12 페이지. Easymini control box
페이지 인쇄The hydro-massage is regulated and set by using the pump on low or high speed (see display), activating the venturi system, regulating the water
direction and opening/closing individual jets.
4.1
Regulating the Jet power
The pump forces a large amount of water through the jets. It is possible to add more force to the jets by adding air to the water with the use of the
venturi system.
The air supply is regulated using one of the venturi air valves. Turn the valve to the left to open the air supply or to the right to close the air supply.
Each seat (combination) has its own venturi air valve.
You will only see an effect when the pump is operating at high speed. The air valves are the small controllers found on the top edge of the spa.
To regulate the water distribution, the large controller (diverter) can be used (only when present on the spa). By turning this water controller, it
distributes the water flow to the desired seat(s) in the Spa.
Using these diverter the desired massage intensity can be set. Turn the pump off before setting/turning the diverter in the desired direction.
4.2
Jets
Each 4SeasonsSpa is equipped with the WIRP-system, based on 4 different
types of jets. Each jet type offers a different massage and comes in a variety
of sizes. Each individual jet can be opened and closed by turning it clockwise
or anti-clockwise.
The Spa is emptied by using the gravity drain. Enter the technical compartment and to open the gravity drain remove the first cap and turn
the valve counter clockwise, after that pull the valve open, water will then flow out. Only empty the Spa when the power to the Spa is completely
shut-off. Never leave the Spa empty during frosty periods as water might remain in the tubes and cause serious damage.
4
Hydro-massage
5 Emptying the Spa
9