CookTek SinAqua IHW061-24 설치, 작동 및 사용 설명서 - 페이지 10
{카테고리_이름} CookTek SinAqua IHW061-24에 대한 설치, 작동 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CookTek SinAqua IHW061-24 11 페이지. Induction holding well
CookTek SinAqua IHW061-24에 대해서도 마찬가지입니다: 설치, 작동 및 사용 설명서 (11 페이지)
페이지 인쇄
WARRANTY STATEMENT - US & CANADA ONLY
9
both ways, but the unit(s) being replaced must be returned. Instructions and
alternate courses of action will be provided by Customer Service. Please save all
packaging materials for possible use in shipping. CookTek assumes no liabilities
whatsoever for any damages incurred in transit. PLEASE BE SURE TO USE
ADEQUATE PACKAGING AND A RELIABLE SHIPPING METHOD OR, IF USING
THE ARP PROGRAM, USE THE SAME BOX THE REPLACEMENT UNIT
ARRIVED IN FOR THE RETURN.
OUTSIDE THE USA AND CANADA
CookTek offers NO warranty outside of the USA and Canada. Warranty is
offered and performed at the discretion of CookTek's local Authorized International
Distributor. Contact details can be found at www.cooktek.com/find-rep, or by calling
+1 (312) 563-9600.
For additional information and other details concerning warranty, please contact our
Customer Service Department at:
CookTek Induction Systems, LLC • www.cooktek.com
In the USA, Tel: (888) COOKTEK, 1 (888) 266-5835 • Fax: 1 (888) 266-5329
Outside the USA, Tel: +1 (312) 563-9600 • Fax:+1 (312) 432-6220
ERROR CODES
In the event of a possible malfunction, your CookTek IHW will display an error code
on the alphanumeric display. Some models will beep a specific number of times,
indicated by the error and flash the lights on the control box. Please consult the
following table when encountering an error code. To reset error conditions, remove
the pan from the unit and press the Power button, or unplug the unit.
Error Error Cause
Displayed Message Troubleshooting
Broken
1
Temperature
E-01
Sensor
Broken Temp
2
Sensor, Pan Temp
E-02
Too High
3
Over current (peak)
E-03
6
High line voltage
E-06
7
Harware failure
E-07
8
Zero cross failure
E-08
13
User interface error
E-13
16
Critical error
E-16
Service required
Remove any pans from the IHW
surface and let cool. Turn unit off
and on to reset error. If problem
persists, contact service provider.
Try different cookware. Service
may be required.
To reset, unplug unit, wait 5
seconds, and plug in again. If
problem persists, have an
electrician monitor the line
voltage.
Service required.
Turn unit off, then on. Plug unit
into outlet on different circuit
breaker. If problem persists,
service is required on device
Check control panel connection,
cycle power. Service required
Call dealer for service. Service
required.
Manual IHW 14049_A USINTL
10