Cookworks 135891082 관리 및 사용 설명서 - 페이지 5

{카테고리_이름} Cookworks 135891082에 대한 관리 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookworks 135891082 8 페이지. Pyramid kettle

TO USE

1. Place the kettle and stand on a stable, flat, heat resistant

surface and away from surfaces that may be damaged by

steam.

2. Fully unwind the cable from the stand and plug in. For safety

do not allow the cable to dangle over the edge of units.

3. Remove the kettle from the stand; remove the lid and fill to

the required level using the markings on the clear water

gauge as a guide. Do not fill past the MAX (1.7 litre / 7 cups)

or below the MIN (0.75 litre / 3 cups) level.

4. Close the lid fully until it clips into place and ensure that the

switch is in the off position (lift switch up) before replacing

on the stand.

5. Turn the kettle so that the spout faces away from you and

switch the kettle on by pressing the switch downward (I). The

kettle will start to operate and the power indicator (in the

switch) will illuminate.

6. When the water boils, the kettle will switch off automatically

and the indicator light will go off.

7. To stop or interrupt the boiling process, switch the appliance

off by lifting the switch up before removing the kettle from

the stand.

Notes:

•

Before using for the first time, fill the kettle to the maximum

level, bring to the boil and then discard water. Repeat this

step two further times.

•

This kettle is fitted with a safety device that automatically

switches off the heater element if the appliance is

inadvertently switched on when empty or if it boils dry. In

this case allow the kettle to cool completely (minimum 15

minutes) before refilling with cold water.

resume operation after refilling.

Issue 3 27/08/2021

The kettle will