Austria Email EBH-KDW 작동 및 장착 지침 매뉴얼 - 페이지 5

{카테고리_이름} Austria Email EBH-KDW에 대한 작동 및 장착 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Austria Email EBH-KDW 14 페이지.
Austria Email EBH-KDW에 대해서도 마찬가지입니다: 작동 및 장착 지침 매뉴얼 (14 페이지)

페이지 인쇄

5.2 Assembly of Built-in Heater

In addition to the legally approved regulations, the connecting requirements of the local power company and waterworks

must be complied with.

1. Remove cover on tank.

2. Install heating flange "item 2" in boiler using sealing ring "item 3".

The sensor protection tube of the temperature control must be located above the tubular heating unit(s)

when installed (see information for installation).

3. Attach the heating flange "item 2" using flange screws M12 (max. turning moment 22 Nm).

Tighten the flange screws crosswise.

The screwed connection of the heating unit must be checked and retightened using a turning moment of

2-3 Nm, if necessary.

4. Produce power connection according to the circuit diagram (see section 5.5).

Important – do not forget: connect protective conductor!

5. Mount covering cap "item 1" on tank. Put on enclosed control toggle "item 4", set desired service water

temperature.

6. Do not put into operation until the tank is filled with water.

The assembly of the heating installation and the initial start-up must be performed exclusively by an expert, who thereby

accepts responsibility for proper implementation and equipping.

5.3 Information on Corrosion Protection

The built-in heater is designed for installation in enamelled tanks. If the heater is installed in foreign makes, then the sup-

plier of the boiler must ensure sufficient corrosion protection. First control of the anode is after approx. 2 years operating

time. The protective anodes should be replaced if more than 3/4 of the material have degraded.

The following measure is required in the event of a combination with CrNi (NIRO) tanks or CrNi heat exchangers and

installations in plastic-coated tanks:

a) Disconnect the guard circuit shunt resistor to ensure insulated installation of the heating unit.

Id.Nr.: 228557-10