Cookworks CBES 작동 및 설치 지침 - 페이지 9

{카테고리_이름} Cookworks CBES에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cookworks CBES 18 페이지.

페이지 인쇄

The dimensions and material of the cabinet in

which the oven will be installed must be

appropriate and resistant to increases in

temperature. In a correct installation, contact

with electrical or insulated parts must be

prevented. Insulating parts need to be fitted in a

way to ensure that they cannot be removed by

using any kind of tool. Installing the appliance in

the close vicinity of a refrigerator or a deep-

freezer is not recommended. Otherwise, the

performance of the above -mentioned appliances

will be negatively affected due to emanating

heat. After removing your oven from its

packaging, be sure that the oven is not

damaged. If you suspect of any damage to the

appliance, do not use it; immediately contact the

Authorised Service agent.

WIRING AND SAFETY OF BUILT-IN OVEN

The instructions given below must be followed

without fail during wiring :

The earthing cable must be connected via the

screw with the earthing mark. Feeder cable

connection must be as shown in Figure 6. If

there is no earthed outlet conforming to

regulations in the installation environment, call

the Authorised Service immediately.

The earthed outlet must be in close vicinity of

the appliance. Never use an extension cord.

The feeder cable should not contact the

products hot surface.

In case of any damage to the feeder cable,

please call the Authorised Service agent. The

cable must be replaced by the Authorised

Service agent.

Wiring of the appliance must be performed by

the Authorized Service agent. HO5VV-F type

feeder cable must be used.

Faulty wiring may damage the appliance. Such

damage will not be covered under the warranty.

The appliance is designed to connect to 220-

240V-- electricty supply if your household supply

is different than the value given above, call the

Authorized Service immediately.

The Manucaturer declares that it bears no

responsibility whatsover for any

kind of damage and loss arising from not

complying with these safety instructions.

U i

GENERAL WARNING AND PRECAUTIONS

Your appliance is produced in conformity with the

relevant safety regulations relating to electrical

appliances. Maintanance and repair works must

performed only by Authorised Service

technicians or suitably qualified. Installation and

repair works, performed without observing the

rules may be dangerous.

The outer surfaces are heated while your

appliance is operating. The elements heating the

inner surface of the oven and the steam out are

extremely hot. These sections will continue to

preserve their heat for certain while even if the

appliance is switched off. Never touch the hot

surfaces. Keep children away.

Do not move away from the hob while cooking with

fat or oil. Flaring may occur in case of overheating.

Never pour water into flaring oil.

In order to cook in your oven, the oven function and

temperature setting butttons need to be adjusted

and the oven timer, if avaible, needs to be

Otherwise, the oven will

programmed.

operate.

While the oven door or drawer is open, do not

place anything on it. You may disturb the balance

of the appliance or break the door.

Protect your appliance from atmospheric effects.

Do not leave it under the effects of the sun,rain,

snow, dust etc.

not