AFCO 633 설치 및 작동 지침 - 페이지 4

{카테고리_이름} AFCO 633에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AFCO 633 4 페이지. Compact fogger

Problem

A) Fogger will not draw chemical or is sputtering

B) Fog is too wet

Startup

1. Air line too small, not enough air pressure or volume

See REQUIREMENTS, page 1.

2. Air pressure too high.

Slightly close the air supply valve to lower the pressure by

lowering the volume till the fogger smooths out.

3. Chemical tube kinked or not immersed in chemical or chemical

depleted.

Straighten tube / replenish chemical

4. Drawing too much solution

Install optional metering tip

PREVENTIVE MAINTENANCE: When the unit will be out of service for extended periods, place chemical tube(s) in water and flush

the chemical out of the unit to help prevent chemical from drying out and causing build-up. Periodically check and clean chemical

strainer and replace if missing.

Printed: Thursday Jun 26th 2014

Troubleshooting Guide

AF 950001-B • 633 Compact Fogger

Startup

1, 2, 3, 4

1, 4

Possible Cause / Solution

- Page 4 -

Possible Cause / Solution

Maintenance

5. Pin hole or cut in suction tube

Replace suction tube.

6. Chemical tube clogged up

Clean or replace

7. Metering tip or metering tip holder clogged

Clean or replace metering tip and/or metering tip holder.

8. Debris clogging the fogger inlet jets

Disconnect air supply, remove fogger bodies and visually inspect;

remove debris from fogger inlet.

Maintenance

6, 7, 8