Austro Flamm PUR 매뉴얼 - 페이지 7

{카테고리_이름} Austro Flamm PUR에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Austro Flamm PUR 16 페이지.

Austro Flamm PUR 매뉴얼
english
Floor load capacity
Make sure that the load capacity of the supporting
construction is sufficient to carry the weight of the
entire unit before the heating unit is installed.
Combustion air
Being the user of the stove you must take care of a
sufficient combustion air supply. Sealed-up windows
and doors may not allow a sufficient combustion air
supply or disturb the draught behaviour of your stove.
Please ensure the additional supply of fresh
3. CORRECT OPERATION OF YOUR STOVE
Initial startup of your stove
Your stove was treated with a special environmentally
friendly lacquer. The lacquer surface is still soft when
the stove is deliverd. The lacquer will harden when
your stove is used for the first time. The lacquer
surface must not be touched when it is heated for the
first time. The stove must be initially heated at a high
temperature for at least 1.5 hours. Visible vapors may
appear during the hardening of the lacquer. Therefore
it will be necessary to open the windows during the
initial operation in order let the vapors escape into the
outdoors.
PLEASE TAKE NOTE: It takes several heating
sessions before for your stove releases only the
pleasant smell of burning wood.
Approved fuels
Dry, well cured and natural wood (hardwood
preferred), wood briquettes.
Maximum amount of fuel
Maximum amount of fuel to be added: 1,5 kg wood or
1 kg wood briquettes. Larger amounts of fuel can lead
to overheating and thus damage the stove.
Clean burning
The wood must be dry (relative wood moisture
< 15%) and untreated. The right amount of wood
must be burned in order to ensure a clean fire that
releases only small amounts of emissions.
Making a fire
Prepare everything you need for starting the fire soft
wood chips, igniter materials (such as Austroflamm
wood lighter), wood. Figure 1 provides a good
overview of quantity of the materials you will need.
Open the primary and secondary air all the way.
Move both sliders. See figure 2.
Open the stove door.
Put ignition aid on the floor of the firebox.
Lay soft wood chips onto the paper.
5
combustion air if necessary. For details please
consult your specialist retailer.
Stove pipe connection
For your own safety stringent laws apply for
connecting the stove pipes to the chimney. Your
professional dealer or distributor knows these laws.
Please have your certified retailer carry out the
connection of your stove.
Lay one or two logs of wood on the wood chips.
Figure 3: igniting the fire
Light the ignition aid. Close the firebox door. As soon
as the chips burn well, close the primary air supply
See figure 2.
Figure 4: close the primary air
As soon as the wood logs are burning well too, you
can regulate the heating capacity with the secondary
air slider. (slider set to the maximum ("AUF") setting
produces maximum heat – see figure 2.)
When adding wood to the fire, follow the same
procedure as when igniting the fire: Open primary air,
open secondary air, carefully open firebox door, lay
wood on the fire, close the firebox door.
Wait until the added wood catches fire and is burning.
Then close the primary air. Subsequently regulate the
fire with the secondary air supply.
Pur
.