Austro Flamm 63x40x42 사용 설명서 - 페이지 11

{카테고리_이름} Austro Flamm 63x40x42에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Austro Flamm 63x40x42 17 페이지.

7. Special advice

Please mind that all surfaces of the insert heat up extremely during operation. Please

•

use the heat-proof glove, which comes with the insert. Please also make your children

aware of this danger and keep them away from the fireplace during operation.

•

In order to avoid a heat build-up, please DO NOT cover or close any air grids/in-

/outlets.

•

Every insert is made for a special fuel load and therefore has its own maximum fuel

quantity. Bigger quantities than the ones listed below may lead to overheating and

damages of the fireplace!

Maximum fuel quantities – pls. see 3. technical data

The second fuel reload should be made after approx. 45 min after the first. Further fuel

reloads can be made, but please prolong the intervals and reduce the fuel quantity (by 0,5 –

1 kg).

If the manufacturer's dimensional instructions for combustion air cross sections and flue

dimensions cannot be kept or are changed afterwards, all warranty and guarantee claims

end.

No flammable elements may be placed in the insert's radiation area closer than – see 3.

technical data measured from the bottom edge of the combustion chamber. Next to the

fireplace casing a maximum distance of 5 cm must be kept for objects made of flammable

materials.

measure „a") see techn.data „radiation area around glass"

•

construction type A1: Inserts are tested and certified according to this type and are

equipped with a self-closing door, which means that an operation with open door is

no longer allowed. This means that special closing mechanisms have been installed

on the insert, to avoid the door staying open during operation. It is not allowed to carry

out modifications on the insert, which may afterwards allow the operation of the insert

with an open door. For putting in more wood or cleaning the door glass, the door must

be held open against the clamping force of the door spring or the sliding mechanism

and it must not be blocked with any jamming gadget.

Only original spare parts or spare parts which have explicitly been approved or offered

•

by the manufacturer may be used. Please ask your stove fitter or a specialised

Austroflamm dealer.

•

The insert/fireplace must not be modified!

The fireplace can only operate correctly if there is a sufficient air supply in the installation room

respectively for the insert. Take care of a sufficient air supply before you start firing up your fireplace.

Open the combustion air flap on the fireplace and keep it open during the whole time of operation.

Equipment concerning the combustion air supply must not be altered.