aFe Power 440-401006-N 사용 설명서 - 페이지 11

{카테고리_이름} aFe Power 440-401006-N에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aFe Power 440-401006-N 13 페이지. Heavy rate racing sway bar pillow mounts

Initial Setup

For best performance, remove any pre-load in the sway bar while the suspension is

loaded. This is best done on a four post lift, but it is also possible to set the car down on

blocks or ramps so that the end links can be accessed while the suspension is loaded.

Disconnect the end link from the sway bar arm at one end of the sway bar. Adjust the

length of the end link so that the bolt can be slipped through the end link and the hole in

the sway bar arm without having to apply any force to the arm to get the parts to line up

perfectly.

After the end link length is adjusted to remove any preload, lock down the length by

tightening the jam nuts.

For the initial setting of the sway bars we recommend position 2 for both the front and

rear sway bars. For most applications this will be a satisfactory setting and is a good

starting point for all cars.

End Link Stud Nuts

End Link to Sway Bar Arm Bolts

Sway Bar Arm Pinch Bolts

Front Bushing Bracket Bolts

Rear Bushing Bracket Bolts

Rear Bushing Bracket Nuts

Please contact aFe Control Customer Support with any questions!

Fastener Torque Specifications

Application

Torque Spec

Metric

English

76 N-m

56 lb-ft

45 N-m

33 lb-ft

18 N-m

13 lb-ft

58 N-m

43 lb-ft

65 N-m

49 lb-ft

95 N-m

70 lb-ft

00P-0T1027-A