ADE Optima G3 사용 설명서 - 페이지 14
{카테고리_이름} ADE Optima G3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE Optima G3 17 페이지. Intruder alarm system
페이지 인쇄
Operating instructions
How to test your alarm system
You should check that your alarm system still works correctly by periodically carrying out the
alarm system tests described here.
How to test the Strobe, External Siren and Internal Sounders
1.
Prog
Press
and enter your 4 digit user code
0
1
indicator will light and the Day indicator will
go out to indicate that you are in Programming
mode.
2.
0
Press
to select alarm test mode. The
Attack indicator lights to indicate that you are
in alarm test mode.
3.
Strobe test
2
Press
to test the strobe light. This is
normally mounted on the external siren. It
should produce a bright flash at a rate of 1
flash every few seconds. Press
this test.
Siren (Bell) Test
3
Press
to test the external siren, this should
produce a loud alarm sound. Press
this test.
Sounder Low Volume Test
4
Press
to test the Low volume sounder.
This should produce a low volume alarm
sound. Press
Sounder High Volume Test
5
Press
to test the High volume sounder.
This should produce a high volume alarm
sound. Press
14
2
3
. The TA (Tamper)
0
0
to stop this test.
0
to stop this test.
1 2 3 4 5 6 7 8
ZONES
Panel
3
1
2
Remote Keypad
1 2 3 4 5 6 7 8
ZONES
Panel
1
2
3
Remote Keypad
to stop
External siren
0
to stop
Internal low volume
sound
Internal high volume
sound
Power
Attack
Tamper
Day
ZONE
4
5
6
7
8
TA
PA
Day
Power
Power
Attack
Tamper
Day
ZONE
4
5
6
7
8
TA
PA
Day
Power
Strobe On
Day
Day
Day
Day