4x4 TOUGH 17-031000 사용 설명서 - 페이지 9

{카테고리_이름} 4x4 TOUGH 17-031000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4x4 TOUGH 17-031000 12 페이지.

INSTRUCTIONS FOR USE

This Jump Starter has been engineered to address a variety of situations which could confront a

motorist with a disabled vehicle.

The operational sequence is determined by the status of the de cient battery.

This sequence must be followed according to the instructions below.

1.0. Below voltage required to start a vehicle

2.0. Well below the voltage required to start a vehicle

3.0. Completely without charge "dead battery"

Start by connecting to the de cient battery. If the Fault/Override indicator light (B) blinks, the

procedure to be followed is rstly, (1) "Below Voltage Required to Start a Vehicle", and should

this fail to fully charge the Jump Starter, revert to the procedure described under (2) "Well

below the Voltage Required to Start a Vehicle".

1.0. Below Voltage Required to Start a Vehicle

Follow this procedure when the Jump Starter is connected to a de cient battery, the Fault/

Override indicator (B) blinks and the Jump Starter is able to be fully charged by the de cient battery.

Connect the battery clamps to the vehicle's battery- red to the positive battery terminal,

1.1

black to the negative battery terminal. When both terminals have been connected the Fault/

Override indicator light (B) will blink.

Activate the charge button, (C) . The Fault/Override indicator light (B) will extinguish.

1.2

Note: If the Fault/Override indicator light does not extinguish,

to activate correctly.

When the charge button has been activated, the voltage level in the battery will be displayed

1.3

on the Battery Charge Level Indicator (A).

As the capacitors in the unit accumulate charge, the lights on the indicator panel will begin to

rise. As the charging process nears completion the two top lights will start to blink green. Finally,

when fully charged, both lights are a xed green and the unit is ready to start the disabled vehicle.

Should the Jump Starter not fully charge (two uppermost lights on Battery Level Indicator,

1.3A

not attain a xed green status), which can occur when the battery is signi cantly run down,

reactivate the charge button.

attempts or an alarm sounds, continue with 2.0 or 3.0 detailed below.

When ready to start the vehicle, press the Start button (D) twice. The Fault/Override

1.4

indicator light (B) will become a xed green light.

Turn the ignition on and your vehicle should start. If the vehicle fails to start,

1.5

repeat steps 1.1 - 1.4 for a maximum of 5 times. If the vehicle still does not start, stop and

continue with 2.0 or 3.0 as detailed below.

After the vehicle has started, the Jump Starter can be disconnected, and the vehicle will

1.6

continue to run.

NOTE: Should the Jump Starter not fully charge after ve

press the Charge button again