4x4Tough 15-50222 사용자 설명서 - 페이지 5

{카테고리_이름} 4x4Tough 15-50222에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4x4Tough 15-50222 8 페이지. Ump starter with compressor

CHARGING WITH AC ADAPTOR

Use a standard 240 volt AC power outlet to charge the jump starter.

Only use the charger provided with the unit.

Keep the power on/off switch in the OFF position whilst charging.

Plug the AC charger into a standard 240 volt AC POWER outlet and the input plug into the jump starters

charging jack.

A full charge from a 240 volt AC source takes approximately 55 hours.

Recharge the unit when the battery status indicator is displaying less than 5 bars.

The red LED charging indicator will be illuminated whilst charging. When charging is completed, unplug

the charger from the AC power outlet and then remove the AC input socket. Remove the AC charger from

the charging jack, press the LED indicator button and check that the 10 LED battery level indicator lights

stay illuminated to indicate a full charge has been completed.

Note:

a) The 10 LED battery level indicator lights will flash until the unit is fully charged.

b) It is important to remove the charger from the unit before pressing the battery status button to obtain a true

battery level reading.

Keep the power on/off switch in the OFF position whilst charging.

Plug the DC charging adaptor into any 12V DC vehicle socket and the input plug into the jump starters

charging jack.

The red charging LED indicator will illuminate while charging. Once the vehicle's engine is turned off the

unit will cease charging

A full charge from DC takes approximately 15 hours, while the car engine is running.

When charging is complete, unplug the charger.

Press the battery status button. The 10 LED indicator lights will stay illuminated indicating a full charge has

been completed.

The solar panel will provide trickle charging which will assist in reducing over-discharging of the built in battery.

Note: In order to achieve the maximum amount of solar charge energy, position the jump starter in a place that

provides sufficient light.

WARNING:

Vehicles equipped with on-board computers may be affected if the engine battery is jump-started. Read your

vehicle owner's manual before attempting to start the vehicle to determine if external starting assistance can

be used. Failure to follow these instructions may cause damage or explosion. Use safety glasses to protect eyes

while jump-starting a battery.

Turn the vehicle ignition OFF. Turn off all your car's accessories such as lights, radio, air conditioning, etc. to

avoid further drain of the battery.

Engage the handbrake or for vehicles with automatic transmission engage the PARK position.

Make sure all switches on the jump starter are turned OFF.

Securely connect the Red (+) clamp to your vehicle battery's positive (+) battery terminal.

Do not connect a clamp to the negative vehicle battery terminal. Connect the black (-) clamp to a

non-moving, earthed metal part of the vehicle.