BENDIX SV-1 SYNCHRO-SV-3 TRAILER RELEASE 매뉴얼 - 페이지 5
{카테고리_이름} BENDIX SV-1 SYNCHRO-SV-3 TRAILER RELEASE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENDIX SV-1 SYNCHRO-SV-3 TRAILER RELEASE 6 페이지. Synchro valve, trailer release valve
페이지 인쇄
ASSEMBLY
Prior to assembly, lubricate the piston, o-rings and body
bores with Dow-Corning 55-M pneumatic grease (Bendix
Pc. No. 291126).
1. Install the inlet/exhaust valve in the body.
2. Install the inlet valve spring and valve stop (SV-1
or spring guide (SV-3
the check valve in the small diameter end of the inlet-
exhaust valve return spring of the SV-4
installing in the body.
3. Install the o-ring on the supply cap nut then install and
tighten the cap nut. Torque to approximately 100 inch
pounds.
4. Install piston return spring in body.
5. Install the small and large diameter o-rings on the piston.
Insert the piston into body. (Piston should now rest on
top of spring.)
6. Install the control port cap nut o-ring on the cap nut then
install and tighten the cap nut in body. Torque to
approximately 275 inch pounds.
7. Install the exhaust check valve if the valve assembly
was so equipped.
8. Perform tests as outlined in the "Operating and Leakage
Tests" section.
™
™
& SV-4
™
valve). NOTE: Install
valve before
™
valve)
5