aFe Power Takeda 56-10005D 사용 설명서 - 페이지 7

{카테고리_이름} aFe Power Takeda 56-10005D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aFe Power Takeda 56-10005D 20 페이지.

Figure D

Refer to Figure D for Steps 7-9

Step 7: Remove the two plastic rivets connecting the factory air inlet to the front of the car. Use a

flat-head screwdriver to press down on the center of the rivet to unlock, and then pull them out.

These plastic rivets will be replaced.

Step 8: With a 10mm socket, extension and ratchet, loosen the three bolts securing the factory

housing to the vehicle. These three bolts will be re-used during the installation of the Takeda

air intake system.

Step 9: Remove the bottom of the factory housing and air inlet as one piece out of the vehicle.

Page 7

REMOVAL

aFepower.com