BENDIX A2LS HYD DRUM BRAKES W-PARKING 매뉴얼 - 페이지 11
{카테고리_이름} BENDIX A2LS HYD DRUM BRAKES W-PARKING에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENDIX A2LS HYD DRUM BRAKES W-PARKING 17 페이지. Hydraulic drum brakes w/parking
페이지 인쇄
DUST BOOT
FIGURE 21 - WHEEL CYLINDER
SCREW ON FULLY AND UNSCREW ONE
COMPLETE TURN
FIGURE 22 - PISTON ADJUSTER
insert the assembly into the bore of the housing until it
engages the wedge cage and rollers, Figure 16. Install
and tighten the stop pin to 16 ft. lbs. (23,3 N.m).
7. Fit the dust boot to the input tappet/piston, lubricate the
piston seal with new DOT 4 brake fluid and install the
seal onto the piston with the lip facing inward, Figure
20. Grease the inside of the dust boot with the grease
supplied and install the input tappet/piston assembly into
the housing bore until it rests on the roller tappet/piston.
Fit the dust boot to the end of the housing.
8. Turn the expander housing in the vise to enable the
wedge return spring to be installed. Locate the spring
ferrule on the spring and compress the spring over the
wedge stem until the pin can be inserted, Figure 16.
Release the spring carefully.
Note: Push in wedge assembly slightly and center it inside
the housing.
9. Install the bleed screw.
10. Install the expander to the backing plate (dirtshield) using
a new gasket, Figure 1, and secure in place with fixing
bolts.
11. Refer to the vehicle service manual and stall the parking
brake chamber. Install bridge pipe and hydraulic hose.
SEAL
PISTON
12. Install the brake shoes following procedures under Brake
Shoe Installation in this manual. Refer to the vehicle
service manual for procedures to bleed the air from the
brake system. After bleeding, manually readjust the brake
shoe to drum clearance as necessary. Refer to Brake
Shoe Adjustment in this manual.
ASSEMBLE WHEEL CYLINDER UNIT
Use all of the parts supplied in the Bendix repair kit to replace
the old parts removed from the cylinder.
1. Lubricate the piston seal, Figure 15, with new DOT 4
brake fluid and install the seal onto the piston with the
lip facing inwards, Figure 21.
Install the dust boot to the piston and smear the inside
of the dust boot with the grease furnished in the kit.
OVERRIDE
WHEEL
RETAINER
RING
GROOVE
IN PISTON
OLD STYLE
OVERRIDE WHEEL
RETAINER RING
GROOVE IN PISTON
HAS BEEN ELIMINATED
NEW STYLE
FIGURE 23 - NEW AND OLD STYLE PISTON AND OVERRIDE
WHEEL
11