BENDIX Wingman FLR20 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} BENDIX Wingman FLR20에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENDIX Wingman FLR20 8 페이지. Radar changeover kits

aPPendIx - RadaR aLIGnment usInG BendIx

a1 LateRaL aLIGnment usInG tHe BendIx

this is the method to use for lateral alignment when a radar and/or bracket is replaced.

Tools needed: Bendix alignment kit, steel clip or plate, Torx T-20 screwdriver and a tape measure.

•

One of the Bendix Alignment Tools part no: K065284 and K096579 — available from Bendix parts outlets — are used.

The alignment procedure also requires a steel clip, part number K073087, [or steel plate, (K105222) along with stretch-

release adhesive tape].

Alignment Tool

with Laser

Guide

Park the vehicle on a level floor. Air suspensions must be charged and stable. Install the steel clip by sliding it

over the sensor, or install the steel plate to the front of the sensor using stretch-release adhesive tape.

Attach the alignment tool onto the clip or plate using its magnetic feet. Inspect to make sure that the alignment

tool is approximately horizontal, width-wise.

Activate the lateral alignment laser light "on" switch. Place the tool into position for the first measurement. (The

tool will be reversed when the second measurement is made.)

Bendix

alignment tools available

K065284

Magnetic

Feet

(3)

K096579

Shorter

Bar

aLIGnment CLIP and tooL

appendix

FLR20

Radar alignment

™

aLIGnment tooL

alignment tool mounting surface

A. Steel Clip

(design may vary)

Mounts by sliding over the

sensor

B. Steel Plate

Mounts using stretch-release

adhesive tape