BENDIX EC-13 TRAILER ANTILOCK CONTROL 매뉴얼 - 페이지 16
{카테고리_이름} BENDIX EC-13 TRAILER ANTILOCK CONTROL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENDIX EC-13 TRAILER ANTILOCK CONTROL 20 페이지. Trailer antilock controller assembly
페이지 인쇄
START HERE
™
M-12
MODULATOR
WIRE HARNESS
CONNECTOR
RESETTING
EC-13
CONTROLLER
MAGNET HERE
16
Troubleshooting
SECTION V PART B
TESTING THE MODULATOR
TURN THE IGNITION OFF. DISCONNECT THE
MODULATOR (M-12
FROM THE VEHICLE WIRE HARNESS TO EXPOSE
THE THREE PIN CONNECTOR LEADING TO THE
M-12
RED TO BLACK
RED TO WHITE
BLACK
WHITE
RED
™
™
™
OR M-12R
) CONNECTOR
™
MODULATOR AND TEST RESISTANCE
BETWEEN THE PINS ON THE
MODULATOR CONNECTOR.
9 TO 12 OHMS
9 TO 12 OHMS
RESISTANCE IN RANGE?
YES
RECONNECT EC-13
™
CONTROLLER TO
™
M-12
MODULATOR. TURN IGNITION
ON AND PASS MAGNET OVER
"RESET" ON EC-14
™
CONTROLLER
AND REMOVE. NOTE REACTION OF
RED LEDS.
ARE ANY RED LEDs
ILLUMINATED?
YES
ARE THE SAME RED
LEDs ILLUMINATED?
NO
GO TO SECTION III - "INSPECTION
FOR ILLUMINATED LEDs"
NO
REPLACE M-12
MODULATOR ASSEMBLY
NO
REPEAT THE "INITIAL
START-UP PROCEDURE"
YES
REPLACE THE
EC-13
™
CONTROLLER.
™