Airwell RC7 사용 설명서 - 페이지 8
{카테고리_이름} Airwell RC7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwell RC7 10 페이지.
페이지 인쇄
OPERATION
OPERATION
I FEEL TEMP FUNCTION OPERATION
Press button IFEEL to activate the IFEEL
function. Thermometer sign will appear on the
LCD operation display
temperature setting. Make sure that the remote
control unit is aimed at the air conditioner, with
the IFEEL sensor in front. Prevent the IFEEL
sensor from being affected by heat sources such
as lamps, heaters, direct sun, etc. or from being
directly affected by the air conditioner air flow.
These may cause the sensor to transmit the
wrong temperature data, thereby disturbing the
performance of the IFEEL function.
ROOM TEMP FUNCTION OPERATION
Press the ROOM button to show the actual room
temperature around the remote control unit.
The measured room temperature and the room
temperature sign
will be displayed.
To cancel the ROOM Temperature display press
on one of the following:
Press again on ROOM Temperature button.
Change of MODE button.
NOTE
Room temperature range is between 6 and 36
in 1 increments. Display should show "HI" or
"LO" to represent temperature that is above
36 or below 6.
LOCK FUNCTION
By pressing LOCK button, the remote control
will lock the last operation program. All the
function buttons will be inoperative, including
START/STOP button. By pressing LOCK button
again the remote control will be released from its
locked position. When lock mode is functioning,
the transmission sign
. Select suitable
will be on.
SETTING THE TIMER
There are four timers that can be selected on
the remote control.Two daily timers (designated
as T1,T2) ,and two optional weekend timers
(designated as WKTI, WKT2) .Each timer can be
selected by pressing TIMER button.
The daily timers T1 and T2 can be set for ON and
OFF separately for two different time periods.
Timer setting will not change until new setting is
input.
The weekend timers WKT1 and WKT2 can be
set for ON and OFF separately for two different
time periods and they are effective two days
only. These timers will be effective on the day of
setting and on the day after only.
At 24:00 on the second day, the WK timer will not
be effective anymore and the daily timer will be
effective again.
WKTI - effective on the setting day
WKT2 - effective one day after the setting day.
NOTE:
1. During the weekend timer operation, the
daily timers will be disabled.
2. The WK timers must be reactivated before
every weekend.
A) HOW TO SET THE ON TIME
1. Press the TIMER button
to select the desired
timer.
2. Press the SET button till
the ON sign blinks.
3. Press the + or - (HOUR)
button until the desired
value is displayed.
4. Press the SET button to
activate the timer.
B) HOW TO SET THE OFF TIME
1. Press the TIMER button to select the desired
timer.
2. Press the SET button till the OFF sign blinks.
7