dymax BlueWave 200 빠른 시작 지침
{카테고리_이름} dymax BlueWave 200에 대한 빠른 시작 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax BlueWave 200 2 페이지. Handheld diaphragm valve
dymax BlueWave 200에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 빠른 시작 지침 (2 페이지), 빠른 시작 지침 (2 페이지), 빠른 시작 지침 (2 페이지)
페이지 인쇄BlueWave
NOTE: This replacement bulb is sold as a spare part to be used only in the relevant Dymax lamp system. Dymax sells
these bulbs for this intended use only.
Bulb replacement is easily accomplished by following the steps
below. Refer to the labeled diagrams under the light source cover.
1. Ensure that the Power Cord is unplugged from the rear of the
unit.
2. Remove the top cover from the BlueWave 200 by loosening the
four cover fasteners.
3. Unplug the Bulb and Lift the Bulb Mounting Bracket (Figure 3)
from it. Remove the Bulb from the Bulb Mount (Figure 4).
Figure 2. Bulb Installed in Bulb Mount
4. Unpack the new Bulb. Take care not to bend the flat Electrode in the center of the Bulb.
Figure 5. Bulb Package (Closed)
5. Install the new Bulb into the unit (Figure 9), plug the Bulb in (Figure 10), and tighten the two Mounting Bracket
Thumbscrews (Figure 11). Re-install the BlueWave 200's cover. Make sure that the center Electrode is positioned as
shown in Figure 12.
®
200 Bulb Installation Procedures
Figure 3. Lift Bulb Mounting Bracket
Figure 6. Bulb Package (Open)
Figure 1. BlueWave 200
Figure 4. Remove Bulb from Bulb Mount
Figure 7. Remove Bulb from Box
Quick Start Instructions
Figure 8. Bulb