dymax BlueWave MX-275 사용자 설명서 - 페이지 13
{카테고리_이름} dymax BlueWave MX-275에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax BlueWave MX-275 20 페이지. Emitter
dymax BlueWave MX-275에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)
페이지 인쇄
Troubleshooting & Maintenance
Problem
BlueWave® MX-275
LED does not
produce light
BlueWave® MX-275
LED suddenly stops
producing light
BlueWave® MX-275
LED provides only
low-intensity light
BlueWave® MX-275 Emitter User Guide
Possible Cause
LED intensity adjustment
set to 0% or too low
LED cycle time is set to 0
seconds
Interlock is open
Interface cable connections
loose or damaged
Trigger setting not
matched to input.
LED head is not connected
to the correct port/channel
Over-temperature
shutdown was triggered
Footswitch defective
Interlock is open
LED intensity adjustment
set to minimum
Contaminated/dirty lens
optics
Corrective Action
Increase LED intensity setting.
0 Seconds sets Manual Mode and
requires a trigger
Verify interlock jumpers are in
place.
Verify PLC command structure for
PLC mode
Check connections and condition
of interface cable
Trigger setting on Admin screen
should match the desired input
trigger channel
Verify that the head is connected
to the desired port/channel
Verify alarms
Activate unit using the front
control panel. Replace the
footswitch if the unit operates
from the front control panel
Verify interlock jumpers are in
place
Verify PLC command structure for
PLC mode
Increase LED intensity setting on
Admin settings or I/O input for PLC
mode
Clean the surface of the lens
13