dymax ACCU-CAL 사용자 설명서 - 페이지 7
{카테고리_이름} dymax ACCU-CAL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax ACCU-CAL 12 페이지. Radiometer
페이지 인쇄Operation
1.
The ACCU-CAL™ 50 Radiometer may be used to
measure UV intensity from Flood Lamps or UV intensity
from the end of a 3-mm, 5-mm, or 8-mm lightguide used
with a Spot Lamp. For Flood Lamp use, attach the
Detector to the Radiometer as shown in Figure 3.
2.
For Spot Lamp use, select an Adapter that matches the
size of the Lightguide that is installed on the Spot Lamp.
3-mm, 5-mm, and 8-mm Adapters are available.
Note: Lightguide Adapters are included in the spot
version (PN 39560) of the ACCU-CAL™ 50 or available
separately.
3.
Install the Lightguide Adapter on the end of the Detector
using the two, 2 mm screws provided.
4.
Attach the Lightguide Adapter to the Spot Lamp
Lightguide by inserting the Lightguide into the
Lightguide Adapter until it bottoms out. Tighten the set
screw when the Lightguide is installed.
5.
Press and release the On/Off Key on the Face Plate to
turn the Radiometer on and off.
6.
Press and release the Light Source Key to select the light
source being measured. The different light source options
are:
•
Flood Lamp - For use when measuring UV intensity of
a flood-lamp light source.
•
3-mm Lightguide - For use when measuring UV
intensity at the end of a 3-mm lightguide.
•
5-mm Lightguide - For use when measuring UV
intensity at the end of a 5-mm lightguide.
•
8-mm Lightguide - For use when measuring UV
intensity at the end of a 8-mm lightguide.
7.
Press and release the Mode Key to select an operating
mode. The different operating modes are:
•
Peak Intensity - Shows the highest UV intensity in
mW/cm
2
seen by the detector during the
measurement.
•
Intensity - Shows the UV intensity in mW/cm
detector during the measurement.
•
Dose - Shows the total UV dose in mJ/cm
detector during the measurement.
U S E R G U I D E
A C C U - C A L ™ 5 0 R A D I O M E T E R
|
Figure 3.
Radiometer with Detector
Figure 4.
Adapter Installation
Figure 5.
Attach Lightguide Adapter to Lightguide (Step 4)
Figure 6.
Face Plate
at the
2
at the
2
7