dymax 41688 사용자 설명서 - 페이지 10

{카테고리_이름} dymax 41688에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax 41688 16 페이지. Ax light shield kit

Plug the AC power cord into an AC power

outlet.

When all connections are properly made, toggle

the power switch on the top of the BlueWave

AX-550 controller. The system is now ready for

use. Verify that the fan on the back of the light

shield is operating.

Set the curing parameters according to

application requirements. Instructions for setting

these parameters and complete unit operation

can be found in the BlueWave

Curing System's User Guide.

Open the light shield door, and verify "LED

INHIBIT OPEN" is displayed across the bottom

of the LCD screen (Figure 11). This indicates

that the light shield is connected and functioning

properly.

NOTE: Curing cycles cannot be started while

"LED INHIBIT OPEN" is displayed on the screen,

preventing accidental light exposure.

10. Estimate the height of the curing part in respect

to its base, or to the base of the part holder (if

the object to be cured is not free standing), and

then adjust the position of the tray to a proper

distance from the curing part. Use a ruler for

setting accuracy. You can set working distances

for each type of LED array assembly differently

to optimize your throughput with respect to

adhesive properties and irradiant energy

required to achieve the best curing quality in the

shortest time. Dymax Application Engineering is

ready to assist you if needed.

11. The system is ready for operation.

D Y M A X . C O M

AX-550 LED

Figure 11.

"LED INHIBIT OPEN" Indicates the Light Shield is

Connected and Functioning Properly

NOTE: If your unit doesn't display the "LED INHIBIT

OPEN" message on the screen when the Light

Shield door is opened, remove all power and do not

operate the unit. Contact Dymax for assistance

Door Open

Indication

U SE R G U I D E

A X - 5 5 0