dymax BlueWave 200 사용자 설명서 - 페이지 12
{카테고리_이름} dymax BlueWave 200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dymax BlueWave 200 16 페이지. Handheld diaphragm valve
dymax BlueWave 200에 대해서도 마찬가지입니다: 빠른 시작 지침 (2 페이지), 빠른 시작 지침 (2 페이지), 빠른 시작 지침 (2 페이지), 빠른 시작 지침 (2 페이지)
페이지 인쇄12
Model 200 Dispensing Valve User Guide
Assembly Instructions
1.
Slide the Standoffs (F) through the bottom of the Valve Top Cap (A) and rotate the
threaded sides outward.
2.
Place the Handle (G) in between the Standoffs (F) and insert the Dowel Pin (J) to
hold in place.
3.
Using a .050" Allen key, thread the two Set Screws (K) into the Standoffs (F) to hold
the Dowel Pin (J) in place, but leave loose until the valve is assembled.
4.
Place the Spring (H) over the Plunger (D) and insert the assembly through the
bottom of the Valve Top Cap (A) and through the cutout in the Handle (G).
5.
Thread the Stroke Adjustment Nut (E) onto the Plunger (D) to hold the Plunger (D)
and Handle (G) assembly together.
6.
Using a .050" Allen key, thread the Set Screw (K) into the Stroke Adjustment Nut
(K).
7.
Place the Diaphragm (B) onto the groove of the Fluid Section (C) with the thin
Teflon® side down, against the fluid.
NOTE: The diaphragm must be assembled into the valve with the Teflon® side
facing the fluid. The Teflon side is the thinner, smooth side.
8.
Mount the Valve Top Cap (A) over the Diaphragm (B) and assemble to the valve's
Fluid Section (C) using the four Socket Head Cap Screws (L). Tighten the Socket
Head Cap Screws down evenly with a 9/64" Allen key.
9.
Tighten the two Set Screws (K) that thread into the Standoffs (F) using a .050" Allen
key.
10. Thread the Plastic Luer Adapter (I) into the bottom of the valve's Fluid Section (C)
and tighten using an adjustable wrench.
NOTE: Be sure not to over tighten the Plastic Luer Adapter (I).