BENE 402 설치 매뉴얼 - 페이지 2

{카테고리_이름} BENE 402에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BENE 402 2 페이지. Parking assist system

Installation Notice

Select place of sensors that tow bar or spare tyres are not obstructing the clear view of the sensors.

Check the size of the hole saw to be compatible to the diameter of the sensor.

Before drilling carefully check area behind proposed hole locations for wiring loom and lower bumper stiffener.

Make sure you follow the correct sensors mounting instructions - do not push the front middle part of the sensor by finger !

Sensors installation

1. Select appropriate positioning for rear sensor.

2. Measure position for the sensor location.

3. Drill hole by attached hole saw.

5. Push the sensors into hole and route wiring harness to control box.

6. Mount the control box into trunk

7. Connect all socket and wire by the wiring diagram.

FUNCTION TEST AFTER INSTALLATION

• Put the shift level to the reverse gear, then the reverse lamp is lighted and system is started.

• The system starts diagnostics connected sensors. If you hear long beep to indicate that one or more sensors have problems.

• For testing use wooden plate or flat object (20x100cm)..

• Stand behind car approximately 1,5 meters and slowly reverse to the vehicle.

• Repeat step above for all sensors.

NOTES

• The system BENE 402 works with the supplied buzzer only.

• The system BENE 402 works with the supplied sensors only.

• The system BENE 402 only warn before the obstruction, not dedicated for precision measure distance out of the obstruction.

• The performance maybe affect in the following situation: heavy rain, the gravel road, bumpy road, sloping road and bush, very hot, cold or

moist weather, the sensors is covered by snow, ice, mud, dust, etc.

• Other ultrasonics, microwave or electric wave maybe affect the performance of the system.

• The manufacturer and its distributors do not guarantee or assume liability for collisions or damages while parking your vehicle.

TECHNICAL PARAMETERS

Operating Voltage

Operating Temperature

Rated Current

Detection range

BENE 402

DC 9 ~ 16V

- 30°C to +70°C

11 -18 mA

0,3m to 1,5m

Set includes

Control box

Sensor

Buzzer

Hole saw ø 21,7 mm

Install manual

1 pcs

4 pcs

1 pcs