Dymo LabelManager 500TS 빠른 참조 매뉴얼 - 페이지 3
{카테고리_이름} Dymo LabelManager 500TS에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelManager 500TS 17 페이지. Dymo labelmanager 500ts label maker
Dymo LabelManager 500TS에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 사용자 설명서 (19 페이지), 개요 (2 페이지), 사양 (2 페이지), 빠른 매뉴얼 (2 페이지)
페이지 인쇄
Charging the Battery
A charging adapter is included with your label maker for recharging the battery
pack. Charging the battery pack will take approximately three hours.
The charging adapter is only used for
recharging the battery pack; the charging
adapter cannot be used to power the
label maker.
To recharge the battery
Plug the charging adapter into the power
1
connector on the top of the label maker.
Plug the other end of the charging
2
adapter into a power outlet.
Make sure to read the LiPo Safety Precautions found on page 15.
Inserting the Label Cassette
Your label maker uses DYMO D1
label cassettes.
To insert the label cassette
Lift the back cover of the label maker to
1
open the label compartment.
Make sure the tape and ribbon are taut
2
across the mouth of the cassette and that
the tape passes between the label guides.
If necessary, turn the ribbon rewind spool
clockwise to tighten the ribbon.
Insert the cassette and press firmly until the
3
cassette clicks into place.
Close the back cover of the label maker.
4
3