Dymo LabelManager Series 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Dymo LabelManager Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelManager Series 17 페이지.
Dymo LabelManager Series에 대해서도 마찬가지입니다: 개요 (12 페이지)

페이지 인쇄

Checking the Label Maker Status

The label maker status is displayed in the software window. The following table

describes the possible states of the label maker. See Figure 6 on page 6.

Charging the Battery Pack

You can charge the battery pack by connecting the label maker to either the

computer or the wall adapter. Fully charging the battery will take approximately

two and a half hours when charged using the wall adapter and approximately

eight hours when charged while connected to a powered USB port on your

computer.

For best performance, fully charge the battery pack before using your

label maker.

Make sure to read the LiPo Safety Precautions found on page 12.

To charge the battery pack from your computer

Connect the label maker to a powered USB port on your computer.

Turn on the computer.

The battery pack will not charge if the computer is turned off or in sleep

mode.

If the label maker is turned off, press the power button to turn the label

maker on and start charging the battery pack.

The label maker must be connected to a powered USB port to charge the

battery. The label maker may not charge or function properly when connected to

a non-powered USB port, such as those on some Mac keyboards or a non-

powered USB hub.

Label maker is connected; battery pack is charging

Label maker is connected; battery pack is not charging

Label maker is not connected or is turned off

Label maker is connected; there is a problem with the

battery pack