Dymo LabelPoint 150 사용자 설명서

{카테고리_이름} Dymo LabelPoint 150에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LabelPoint 150 11 페이지. Multifunctional basic handheld model
Dymo LabelPoint 150에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지), 빠른 매뉴얼 (2 페이지)

페이지 인쇄

About Your New Labelmaker

With your DYMO LabelPOINT

you can create a wide variety of high-quality, self-

adhesive labels. You can choose to print your

labels in many different sizes and styles. The

labelmaker uses DYMO D1 tape cassettes in

widths of 9 mm (3/8") and 12 mm (1/2"). Tape

cassettes are also available in a wide range of

colors.

Visit www.dymo.com for information on obtaining

labels and accessories for your labelmaker.

Warranty Registration

Please complete the warranty registration card and

return it to the appropriate customer service

address within seven days. Visit www.dymo.com

for details.

Getting Started

Follow the instructions in this section to print your

first label.

Connecting the Power

The labelmaker is powered by six AAA batteries.

To save power, the labelmaker will automatically

turn off after two minutes of inactivity.

To insert the batteries

1. Remove the battery compartment cover. See

Figure 2.

Figure 2

™

150 labelmaker,

2. Insert the batteries following the

polarity markings (+ and –).

3. Replace the battery compartment cover.

Remove the batteries if the labelmaker will

not be used for a long period of time.

Inserting the Tape Cassette

Your labelmaker comes with one tape cassette.

Visit www.dymo.com for information about

purchasing additional tape cassettes.

To insert the tape cassette

1. Press and release the tape cassette cover to

open the label compartment. See Figure 3.

Figure 3

The first time you use the labelmaker,

remove the protective cardboard insert from

between the print head and pinch roller. See

Figure 3.

2. Make sure the tape and ribbon are taut across

the mouth of the cassette and that the tape

passes between the guideposts. If necessary,

turn the spool clockwise to tighten the ribbon.

3. Insert the cassette with the tape and ribbon

positioned between the print head and pinch

roller. See Figure 4.

Remove

cardboard insert