510 DESIGN Laurel 조립 지침 - 페이지 3

{카테고리_이름} 510 DESIGN Laurel에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 510 DESIGN Laurel 3 페이지. Desk

Step 4: Assemble the Desk on a flat, soft surface such as carpet or cloth to prevent scratching the finish

Attach the Metal frame to the Top Frame (P1) fully tighten bolts, as shown below.

(H2)x4

Bolts Ø1/4" x 38mm L

(H3)x4

Lock Washers Ø1/4"

(H4)x4

Flat Washers Ø1/4"

(H5)x1

Allen Wrench M4

Step 5:

1) Turn the assembled table to an upright position.

2) Assembly is complete. Failure to follow these instructions may cause the bolts to miss align during assembly.

ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY

SHOULD BE PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY.

ALWAYS CHECK TO ENSURE THAT ALL HARDWARE IS KEPT TIGHTENED.

Thank you for your purchase

Page 3 of 3

Please adjust the Leveler up or down

under each leg until desk is level.