Dymo LP200 사용자 설명서 - 페이지 3
{카테고리_이름} Dymo LP200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo LP200 7 페이지.
페이지 인쇄
The Display
Shift on
Justify
Italic
Outline
ABCDEFGHIJKLMN
CAPS on
BIG font on
The display shows:
• Up to 15 characters, plus the cursor, at one time.
• Function indicators – as shown above.
• The display will flash if you press an incorrect key in a
function sequence.
Function keys
ON/OFF
Switches the power on and off.
• Switches off automatically after two minutes if no keys are
pressed. The last label created will be retained and
displayed when next turned on. Any stored label and
settings will be retained.
Note: If the batteries are removed for more than a few
seconds, all text and settings will be lost.
When power is restored, the display will show a flashing
cursor (no text) and the settings will be full height
standard width text with all other settings off.
CAPITALS
CAPS
• Press for all subsequent characters in UPPER CASE
(CAPITALS), as confirmed by the CAPS indicator in the
display.
• Press again to cancel and return to lower case.
SHIFT KEY
Press and hold down for "shift" position.
• Press and hold
to produce an UPPER CASE (CAPS) character.
• For dual-purpose keys, press and hold
produce the legend above the key.
• Pressing and holding
key, while
is set, will give a lower case character.
CAPS
DELETE
DEL
• Press to delete the character to the left of the cursor, or to
exit certain function key operations.
CLEAR
CLEAR TEXT
+
DEL
• Press to clear all the current text and cancel any fixed
length setting, but leave the text size and other settings
unchanged. Also use to exit or clear certain function
key operations.
Page indicators
Line indicator
Underline
Box
1
2
Mirror on
Vertical text
before pressing an alphabet key
first to
before pressing an alphabet
CURSOR KEY
• Press
character at a time.
Copies on
• Press and hold to scan through the text.
• Press
beginning or end of the line of text.
• When used in conjunction with certain function keys,
use
• To insert characters into the text, use
the cursor under the character to the right of the insertion
point, then type in the characters required.
• Press
previous or next line of a multi-line label.
• Press
beginning or end of the label.
PRINTING
• Press
• Use cutter lever E to release the label – see page 2.
• If the display shows
installed in the machine is too narrow for the label to be
printed; change the cassette to a wider tape.
PREVIEW
Allows you to preview your label before printing it.
• Press
across the display.
On labels with 2 lines, the message will be previewed as a
single line message.
SPACE KEY
• Press
SYMBOLS
• Press to select a symbol character – see SYMBOLS
AND SPECIAL CHARACTERS and the symbols table on
page 2.
TEXT SIZE
• The display shows the current selection of text print
size:
Height
small
normal
• Normal height is available on all except 6mm labels.
Small height is available on all labels.
• Press
Use
to confirm the selection.
4
or
to move the cursor along the text, one
+
or
to move the cursor to the
or
to select options.
or
to move the cursor to the start of the
+
or
to move the cursor to the
PRINT
to print the label.
PRINT
↕↕↕↕↕↕↕↕↕↕
PREVIEW
+
and the entire text will scroll
CAPS
to insert a space into the text.
+
SIZE
Condensed
Normal
to select the size menu:
SIZE
B
to select the size symbol required, then press
or
to position
, the tape cassette
Extended