Dymo RhinoPRO 5000 사용자 설명서 - 페이지 3

{카테고리_이름} Dymo RhinoPRO 5000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dymo RhinoPRO 5000 14 페이지. User guide
Dymo RhinoPRO 5000에 대해서도 마찬가지입니다: 빠른 참조 (2 페이지), 기술 사양 (2 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄

About Your New Printer

With your new DYMO RhinoPRO

you can create a wide variety of high-quality, self-

adhesive labels. You can choose to print your

labels in many different sizes and styles. The

printer uses DYMO RhinoPRO Industrial label

cassettes in widths of 6 mm (1/4"), 9 mm (3/8"),

12 mm (1/2"), or 19 mm (3/4"). RhinoPRO label

cassettes are also available in a wide range of

materials.

Visit www.dymo.com for information on obtaining

tapes and accessories for your printer.

Warranty Registration

Please complete the warranty registration card and

return it to the appropriate address, or you can

Getting Started

Follow the instructions in this section to print your

first label.

Power Supply

The printer is powered by standard batteries, a

rechargeable battery pack or an AC power adapter.

To save power, the printer will automatically turn off

after five minutes of inactivity.

Inserting the Batteries

The printer uses six AA batteries.

To insert the batteries

1. Press the thumb latch on the bottom of the

printer to open the battery compartment door.

See Figure 1.

Manual_RhinoPRO5000_WEU.indd 3

™

5000 printer,

2. Insert the batteries following the polarity

markings (+ and –).

3. Close the battery compartment door.

used for a long period of time.

Using the Battery Pack

An optional, rechargeable battery pack can be

used to power the printer. The battery pack can be

purchased through your local DYMO reseller.

The printer must be connected to external power

through the AC adapter and turned ON to charge

the battery pack. When the battery pack is

completely discharged, allow four to five hours to

fully charge the battery.

battery charging indicator may continue to display

even though the battery pack is fully charged.

To use the battery pack

1. Open the battery compartment door.

2. Insert the battery pack following the polarity

markings (+ and –). See Figure 2.

Figure 1

Remove the batteries if the printer will not be

When connected to external power, the

Figure 2

Press thumb

latch

23-07-2004 10:51:10