Gacell ABC 1600 사용자 설명서 - 페이지 10
{카테고리_이름} Gacell ABC 1600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gacell ABC 1600 16 페이지.
페이지 인쇄USER MANUAL
•
Read this instruction before the charger is taken into use.
•
Keep this manual within easy reach for the user of this battery charger.
•
Hydrogen gas will be produced when charging lead-acid batteries and hydrogen gas is explosive.
•
Open flames and sparks should be kept away from batteries they may produce explosions.
•
The charger should be switched off before the charger/battery plug is disconnected.
•
It is related with real danger to touch any parts inside the charger. Do not do any repair work with the
main switch ON and to be real sure disconnect the mains connector.
General
The ABC Charger is suitable both for Freely Ventilated- (Wet) and Valve Regulated- (Dry) lead/acid batteries.
The charger is small and is very light and can therefore easily be fitted close to the battery. (The charger can be
delivered with program compensating for the equipment base load).
The charger operates in high frequency and should be connected to a standard 230V mains connection with ground.
The built in micro controller controls the charging process according to the chosen charging algorithm.
During charging the charging progress is displayed with a status indicator LED on the front panel. The micro-
controller is also controlling the charging progress with regards to temperature in the charger and time. If a fault
occurs in some cells or the temperature rises the charging current will be limited. If you have a special requirement
of charging algorithm or application, please contact Primepower AB.
Installation
The ABC Charger is mainly suited for indoor use.
It can be used positioned horizontally on a table or a shelf, hang on a wall using the free supplied bracket or as a
built-in charger in the vehicle or machinery. When it is built in it has to be shock absorbed.
The charger can be with fixed connection to the battery or with conventional connectors.
Position the charger in such a way that the air supply will not be obstructed.
When the charger is fitted on a wall or mounted in a vehicle it should be horizontal to limit dust and moisture to
enter it.
Function
Check that battery type and size correspond to the setting of the charger. Also check that the polarity between the
charger and the battery is right. Positive + to positive + and negative – to negative -.
Connect the battery to the charger and switch on the charger.
The charging starts after a few seconds and the status indicator, Orange LED, is lit up.
Orange LED remains on until the battery is fully charged.
Green LED, is lit up when the battery is ready to be used.
Maintenance charging will continue as long as the battery is connected.
ABC600/800: The charger will be reset as soon as the charger is switched off and then on.
1600W version is reset by the red knob on the front or by disconnecting the mains cable.
The charging time depends on the size of battery and the depth of discharge.
A freely ventilated battery (Wet) can be discharged to max. 80% and a valve regulated (Dry) with max 70%.
ABC 600/800/1600 USER MANUAL
Switch off the charger before the battery is disconnected. If the battery is disconnected
without switching of the charger, sparks may be produced.
Idavägen 11 SE-352 46
|
+46 470 72 74 95
|
9