Gacell CT-3800 사용자 설명서 - 페이지 6

{카테고리_이름} Gacell CT-3800에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gacell CT-3800 12 페이지.

6V NORM

(Hold Mode

button for 3

seconds to

enter)

12V LITHIUM

(Hold & Press)

12V REPAIR

(Hold & Press)

These "Hold or / and Press" modes are advanced charging modes that

require your full attention before selecting.

Using 6V NORM (Hold)

This mode is designed for 6V lead-acid batteries only. Consult the

battery manufacturer before using this mode.

Using 12V LITHIUM (Hold & Press)

This mode is designed for 12V lithium-ion batteries only, including

LiFePO4. Some lithium-ion batteries may be unstable and unsuitable for

charging. Consult the lithium battery manufacturer before charging and

ask for recommended charging voltage and current.

Using 12V REPAIR (Hold & Press)

This mode is for LEAD-ACID batteries only. It is an advanced battery

recovery mode for repairing old, idle, stratified or sulfated batteries.

NOT all batteries can be recovered. For optimal results, take the battery

through a full charge cycle, bringing the battery to full charge, before

using this mode. When this mode is chosen, do remember press Mode

button for choosing appropriate 12V Mode(s). One REPAIR cycle can take

up to eight (8) hours to complete the recovery process and will enter to

charge (8 steps charging cycle) when completed. This mode uses a high

charging voltage and may cause some water loss in WET cell batteries.

Plus, some batteries and electronics may be sensitive to high charging

voltages. To minimize risks, disconnect the battery from the vehicle

before using this mode.

Charging 6V WET/GEL/MF/EFB batteries

2-120

(Blue LED)

Charging 12V lithium-ion batteries only,

2-120

including LiFePO4 (White LED)

An advanced battery recovery mode for

repairing old, idle, stratified or sulfated

2-120

batteries. REPAIR Yellow LED + Green LED

(12V)