5D TACTICAL Router JigPro 사용 설명서 - 페이지 4

{카테고리_이름} 5D TACTICAL Router JigPro에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 5D TACTICAL Router JigPro 13 페이지.
5D TACTICAL Router JigPro에 대해서도 마찬가지입니다: 사용 설명서 (7 페이지)

페이지 인쇄

1-7

While grasping Guide Plate, tighten

(4) Jig screws, securing Buffer Plate

and Takedown Adapter.

1-8

Orient Side Plates, observing Left

and Right with flat sides facing out.

Set Guide Plate and receiver assembly atop

Side Plates. Loosely thread (8) Jig Screws and

then tighten.

1-9

While grasping Guide Plate, pass

Phillips screwdriver through

the hole in the Buffer Adapter, and tighten.

Periodically check for tightness during jig use.

1-10

Install the Drill Guide as shown. Loosely

insert (2) Jig Screws, then tighten.

1-11

Clamp Jig Assembly securely in

a vise as shown by the notches

provided in the Side Plates. DO NOT

CLAMP JIG BY OUTSIDE OF SIDE

PLATES. DAMAGE WILL OCCUR.

REVIEW IMAGES CAREFULLY.

PART 2: DRILLING STEP 1

2-1

Spray WD-40 into Drill Guide hole

and insert 21/64" drill bit. Do not

start the drill until the bit is fully inserted.

Using care to keep the drill bit straight and

perpendicular to the receiver, begin drilling.

Periodically pull the drill bit out of the Guide

to clear chips. Apply WD-40 liberally. Drill until

the bit exits the bottom of the receiver.

508-834-4223

5DTACTICAL.COM