5D TACTICAL Router JigPro 사용 설명서 - 페이지 5

{카테고리_이름} 5D TACTICAL Router JigPro에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 5D TACTICAL Router JigPro 7 페이지.
5D TACTICAL Router JigPro에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

PART 5: MILLING STEP 3

Remove #2 (Medium) Guide Pins and

5-1

install #3 (Long) Guide Pins.

Do not over-tighten.

Set end mill depth by using

5-2

Depth Gauge #2.

PART 6: FINAL DRILLING

Clamp Jig Assembly in the Vise by

6-1

the edges of the side plates, with the

RIGHT Side Plate facing up. Ensure that the

assembly is level. Spray WD-40 into the large

Guide Hole and insert 3/8" drill bit. Do not

start drill until bit is fully inserted in the Guide

Hole. Apply moderate pressure and drill until

the bit penetrates the right side wall and

continue drilling through left side wall.

5-3

Place router on Guide Plate, with the

end mill centered within the drill hole.

The Guide Pins should be positioned inside

the #3 Guide Holes on both sides. Gently mill

in a clockwise manner until the trigger slot

is formed

6-2

WD-40 into both small Guide Holes

and insert 5/32" drill bit into either

remaining Guide Hole. Do not start drill until

bit is fully inserted. Apply moderate pressure

and drill until the bit penetrates the right side

wall and continue drilling through left side

wall. Repeat for remaining small Guide Hole.

NOTE: If your drill bits are not long enough to

penetrate both walls, flip jig over and repeat

process. Receivers with spray-on coatings such

as Cerakote and Duracoat should be drilled from

both sides for maximum finish quality.

5DTACTICAL.COM

PART 7: DISASSEMBLY

Remove Buffer Adapter. Loosen or

7-1

completely remove Buffer Plate.

Remove Takedown Pin. The Finished receiver

can now be removed from the jig.

FINAL PRODUCT

Congratulations on completing your lower!

Again, we here at 5D Tactical understand you have chosen to spend your hard earned

money with us, and because of that, we strive for 100% customer satisfaction. Your

Router Jig Pro caries a Lifetime Warranty against manufacturer's defects.

Please contact us by phone at 508-834-4223 or email [email protected]

with any questions or concerns regarding the use of your Router Jig Pro.

Replacement parts, build kits, and 80% lowers are available for purchase on our

website at 5DTACTICAL.COM.

Thank you, and we hope to continue to providing you with quality products!

5DTACTICAL.COM

Remove lower from jig carefully.

7-2

While still wearing ear pro and gloves,

clean off any metal shavings and inspect the

lower to ensure proper procedure has been

executed to complete the lower.