Gadgetree 09A17 운영 지침

{카테고리_이름} Gadgetree 09A17에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gadgetree 09A17 2 페이지. Digital door peephole

페이지 인쇄

GADGETREE DIGITAL DOOR PEEPHOLE

Operating Instructions

Thank you for choosing the Gadgetree Digital Door Peephole.

IDENTIFYING THE PARTS

Lens

2. Barrel

3. Base Flange

4. Digital Peephole Viewer

5. Remove/Install Tool

6. 2 x Locking Screws

Washer

INSTALLATION

FOR DOORS WITH NO EXISTING PEEPHOLE

• Find the centre of the door and mark at the desired height

• Drill a 9/16" (14mm) hole through the door using a standard power drill

• Remove any debris from the hole and proceed to INSTALLATION

FOR DOORS WITH AN EXISTING PEEPHOLE

Remove Existing Peephole Viewer

• Use the Remove/Install Tool to loosen the eyepiece on your existing

peephole. Insert the small tip of the tool into the barrel and turn it

counterclockwise. Once the barrel is loosened, use your ﬁ ngers to

unscrew it from the backside of the door.

Note: You may have to hold the lens with your other hand while you

remove the barrel

Door (Inside)

Barrel

• Pull to remove the existing lens

from the front side of the door

Remove/Install

Door (Outside)

Lens

INSTALLATION

• Remove the battery cover from the peephole viewer by pressing down

and pulling the side tab. Insert 2 AA batteries (not included) according

to the polarity (+/-) marked in the battery compartment. Replace battery

cover. We recommend Inﬁ niCell batteries for maximum performance

Side tab

Battery cover

Note: For holes wider than 9/16" (14mm), place the washer over the

existing hole before inserting the lens. For narrow holes, use a 9/16"

(14mm) bit to widen the existing hole.

• Remove any debris before proceeding with installation

• Insert the new lens through the front side of the door

• Pass the barrel through the base ﬂ ange and insert the barrel into the

hole on the backside of the door. With your other hand press on the

new lens, and turn the barrel with your hand clockwise until it begins to

tighten. Note: Before completely tightening the barrel, make sure the

engraved arrowhead on the base ﬂ ange is pointing upward at the 12

o'clock position. Use the Remove/Install Tool to tighten

• Place the peephole viewer over the base ﬂ ange at an angle as shown

below

Flange

Lens

Door

Washer

• Rotate the peephole viewer clockwise until it stops

• Insert the locking screw into the screw hole located on the underside

of the peephole viewer. Tighten the locking screw with a Phillips

screwdriver to securely lock the peephole viewer into place

Base ﬂ ange

8069219

Battery

compartment

Barrel

Insert locking

screw here