AFF 3182 소유자 매뉴얼 - 페이지 3
{카테고리_이름} AFF 3182에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFF 3182 7 페이지. 2,500 lbs power train table/lift
페이지 인쇄WARNING (continued)
!
•
Adequately support the vehicle before starting repairs. Consult the in ground or above ground
lift manufacturer for the recommended support procedure and under hoist support stand locating
points.
•
Support the engine with a stand before unbolting the transmission from the engine.
•
Never remove, install, or transport any component without first tightly securing it to the universal
saddle.
•
Do not move the lift table when the load is raised. Always lower the load completely before moving,
storing, or using as a work table.
•
Do not stand under a load that is raised by the lift table.
•
No alterations shall be made to the lift table.
SETUP
1.
Refer to the exploded parts drawing for identification, location, and position of parts.
2.
Use at least 1-1/2 wraps of Teflon tape (or suitable sealant) on all hose fitting threads. Make sure the
first complete thread is free from tape or sealant so they do not enter and contaminate the hydraulic
system.
3.
The air quick disconnect configuration of your choice can be installed in the threaded hole underneath
the foot pedal.
4.
Install the hydraulic hose into the pump manifold's threaded hole. Thread the hose fitting into the
pump manifold's threaded hole and turn until snug.
5.
To prevent oil leak during transit a metal knob has been installed and tightened on the foot pump.
Loosen the metal knob counterclockwise before first use.
6.
Connect the air supply line to the foot pump. For best results air supply should be 5-10 CFM at 100
PSI and equipped with an air filter. Do not exceed 120 PSI.
7.
The power train lift table is equipped with a universal saddle for better versatility.
Page 3