Adel CBI123ARJ 사용 설명서 - 페이지 2

{카테고리_이름} Adel CBI123ARJ에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Adel CBI123ARJ 4 페이지. Intelligent battery charger

페이지 인쇄

________________________________________________________Battery Charger

Rail mounting:

Other modules must have a minimum vertical distance of 10 cm to this power supply in order to guarantee sufficient auto

convection.

Use and Connections

Caution:

Switch off the system before connecting the module. Never work on the machine when it is live.

Charging Level Current: With trimmer from 20% to 100% of In. Select the max. battery charge current estimated from 10 to 25% of

the nominal capacity.

Battery module (Output 1) 3-4 Pin: Battery Input and diagnosi led: very fast blinking= recovery charging ( when the battery is too

low) , fast blinking=fast charge, slow blinking=trickle charge

Out Load (Output 2) 1-2 Pin: Output voltage 12 Vdc is made via the +, - .

Mains or Backup: Mains with led off and closed contact (5-6), Backup with led on and closed contact (5-7).

Note: switching of the relay Backup should be filtered with a delay of at least 5 seconds, example: connection to PLC.

Low Battery or Battery replacement: Normal condition with battery OK, led Off and closed contact (8-9), Low Battery with battery

NOK, led ON and closed contact (8-10), Battery replacement alarm with Power ON , led ON and closed contact (8-10); (see

diagnostic Led )

Life Test Battery : In trickle charge condition check every 4 hours, internal impedance (5 blinking Diagnosis Led)

Diagnosis Led

Very fast blinking= recovery charging ( when the battery is too low, Under 10 Vdc)

Fast blinking= fast charge.

Slow blinking= trickle charge (floating charge)

1 blinking= Reverse polarity battery; Bad input voltage battery.

2 blinking= Battery not connected.

3 blinking= Short circuit battery element.

4 blinking= Over Load.

5 blinking= Bad battery.( Internal impedance Bad or Bad battery wire connection)

Battery Type Configurations

Position jumper Setting:

•

Open Lead (Charge): Trickle =2.23 Fast=2.40/cell

•

Sealed Lead (Charge): Trickle =2.25 Fast=2.40/cell

•

Sealed Lead (Charge): Trickle =2.27 Fast=2.40/cell

•

Gel Battery (Charge): Trickle =2.30 Fast=2.40/cell

•

Life Test Battery

INSTRUCTION MANUAL

Assembly: pull down the plastic block with

a screwdriver, place the CB on the rail and

release the plastic block.

The CB is now assembled on the rail.

Caution:

Only jumper in position 5 Refresh ON/OFF state whit Power.

Notice: in the model CBIxxxA/S, without mains voltage,

closing the contact pos. 5 for 1 second and will start-up the

unit.

All specification are subject to change without notice

Disassembly: pull down the plastic block and pullout

the module like the arrow in the scheme

Switch off the system before Setting the jumper.

CBI123A_R8 Eng.doc