Active Products ZE02 매뉴얼 - 페이지 14

{카테고리_이름} Active Products ZE02에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Active Products ZE02 18 페이지.

USER MAINTENANCE

Connections

Connections on pressure washer hoses, gun and spray wand should be cleaned regularly and lubricated

with non-water soluable grease.

Fig. 13

Adjustable Nozzle

When the nozzle is clogged, it will cause the pump to

build pressure and may cause the unit to surge. You

can clean the nozzle by inserting needle (N) into the

tip to rid it of the deposits.

For the adjustable nozzle, you can also lubricate the

nozzle collar (high-pressure low-pressure) by using

non-water soluble grease regularly.

SERVICING SHOULD BE PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE. CHECK WITH YOUR

LOCAL RETAILERS FOR THE WARRANTY POLICY AND SERVICE OPTION.

Fig. 14

Water Filter Screen

The pressure washer is equipped with a water inlet

filter (L) that prevents debris going into the pump.

If the filter is not kept clean, the flow of water to the

pressure washer will be restricted and the pump

may be damaged.

1. To clean the screen, remove quick connector and

remove the filter screen from the pump inlet.

2. Rinse screen until it is free of debris and blockage.

3. Replace screen and quick-connector immediately.

Air Vents

The air vents located on the front and back of the

pressure washer must be kept clean and free of any

obstructions to ensure proper air-cooling of the mo-

tor during operation.