Active Products ZE02 매뉴얼 - 페이지 4

{카테고리_이름} Active Products ZE02에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Active Products ZE02 18 페이지.

페이지 인쇄

SAFETY FEATURES AND ELECTRICAL POWER INFORMATION

The pressure washer is equipped with a stop de-

vice that will sense when the trigger on the gun is

released. It will open the power circuit to the motor

and cause the pressure washer motor to stop. Motor

will resume again when trigger is pulled.

WARNING

The pressure washer is also equipped with

a main power "ON/OFF" switch located on

the unit. It should always be moved to the

"OFF" position when the pressure washer

is not being used to prevent possible injury

or damage.

Ground Fault Circuit Interrupter:

This pressure washer has a ground-fault circuit-in-

terrupter (GFCI) built into the plug of the power sup-

ply cord. This device provides additional protection

from the risk of shock. Should replacement of the

plug or cord become necessary, use only identical

replacement parts that include GFCI protection.

Extension Cords

If possible, do not use extension cords with this

product. However, if you must use one, observe all

the warnings and instructions listed below:

WARNING

Extension cords are not recommended

unless they are plugged into a ground fault

circuit-interrupter found in circuit boxes or

protected receptacles.

Use a sufficient gauge:

Maximum cable length: 50 ft = 14 AWG

• Use only extension cords that are intended for out-

door use. These extension cords are identified by

a marking "Acceptable for use with outdoor appli-

ances; store indoors while not in use."

• Use only extension cords having an electrical rat-

ing not less than the rating of the product.

• Do not use damaged extension cords. Examine

extension cord before using and replace if dam-

aged. Do not abuse extension cord and do not

yank on any cord to disconnect.

• Keep cord away from heat and sharp edges.

• Always disconnect the extension cord from the re-

ceptacle before disconnecting the product from the

extension cord.

• To reduce the risk of electrocution, keep all con-

nections dry and off the ground. Do not touch plug

with wet hands.