HHO Plus CCPWM60A 설치 매뉴얼 - 페이지 10

{카테고리_이름} HHO Plus CCPWM60A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HHO Plus CCPWM60A 11 페이지. Hho hydrogen on demand dual fuel generator systems
HHO Plus CCPWM60A에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (10 페이지)

페이지 인쇄

The electrolyte should be added to the water the first time that you use the system, and also when refilling,

but in lower quantities. The more electrolyte you add to the water, the more amperage you will have in the

system and also more HHO gas will be produced. But, it is false to assume that a higher HHO gas production

will mean a higher fuel savings. There is an optimum point for all internal combustions engines. The

maximum amperage of the PWM will be set by the electrolyte concentration in the water. The PWM will

only control the amperage below this value.

Please use the following electrolyte concentration when using our CCPWM for the first time:

• 12V -> 20 grs KOH/liter

• 24V -> 10 grs KOH/liter

IMPORTANT: If the CCPWM turns ON and shuts down right after, and repeats this

continuously, then you are using too much electrolyte. Please remove the solution

and add a new one.

Water Level Sensor

The water level should be placed in a way that, when the water

level is above the minimum value, the signal coming from the

CCPWM does not return to the CCPWM. That is, the water level

circuit should operate as normally open (NO). Using our

company models, the water level sensor should be placed up

(please check last picture on this manual).

If you are not using a water level sensor in your system, no

operation is required.

CCPWM60A – Installation Manual