DAW Industries EZ-Access DAWSKIN 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} DAW Industries EZ-Access DAWSKIN에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAW Industries EZ-Access DAWSKIN 8 페이지.
페이지 인쇄
STEP
5
USING A EXPULSION VALVE?
Preserve The DAWSKIN's Appearance By Using A Color-Matched Valve Patch (DSK-VP).
1. Make a circular hole in your DAWSKIN and Foam
Cover no larger than 1 5/8 inches in diameter.
2. Apply a thin layer of DAW S-Glue (DSK-SG) onto
the underside of your Valve Patch around the
flap portion. The thinner, the better, as any glue
spreading out beyond the patch will be visible on
the surface of the DAWSKIN.
3. Center the Valve Patch over the foam cover's
expulsion valve hole. Hold for 20 seconds as the
S-Glue cures.
Air can now exit the prosthesis without damaging your DAWSKIN's integrity or appearance!
CAUTION:
S-Glue must be applied sparingly. Excess application will generate heat, which
can damage the DAWSKIN. Maintain even, sparing application using applicator nozzle.
DAW
DAW
Industries
Do
4
S-Glue
®
Technical Support (800) 242-8669
© Copyright 2021, DAW Industries, San Diego, CA, All Rights Reserved 07162021
Do Not
✘
S-Glue
Pg. 6
1
⁄
in
5
8
(41mm)
Underside
S-Glue
www.daw-usa.com
•
3in
(76mm)