Gage Bilt 640A-50 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Gage Bilt 640A-50에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt 640A-50 4 페이지.

페이지 인쇄

INSTALLATION INSTRUCTIONS

FOR ATTACHING TO GB740 TOOL

1. Connect tool to air supply, making sure head piston of the tool is

in its full forward position.

2. Screw pulling head onto piston assy (740409) on tool.

3. After pulling head is attached, then back off pulling head until

hole in the adapter sleeve (60415) lines up with one of holes in

nose fitting (740101) on tool.

4. Secure to tool using Soc. Hd. Cap Screws (401208) with lined up

hole. Secure second screw in secondary location. See GB740

tool manual.

INSTALLATION INSTRUCTIONS USING 784740

ADAPTER FOR ATTACHING TO GB784 TOOL

*For 5/32"-1/4" only

To install 1/8" CherryLOCK rivets use

GB715 and 615A-61 nose assembly

1. Connect tool to air supply, making sure head piston of the tool is

in its full forward position.

2. Install adapter (784740) onto tool.

Adapter (784740) screws onto head piston (784112) on tool.

Adapter

(784740)

Cherrylock® is a registered trademark of Cherry Aerospace Fasteners. Lubriplate® is a registered trademark of Friske Brothers Refining Co.

GAGE B I LT

● 640A-50 Pulling Heads

Seller warrants that all goods covered by this catalog will conform

to applicable specifications and will replace or repair, EXW our plant, any

goods providing defective from faulty workmanship, or material, for 1 year

from date of shipment

Said warranty to remain in effect if, and only if, such goods are

used in accordance with all instructions as to maintenance, operation and

use, set forth in manuals and instruction sheets furnished by seller.

Sellers obligation under this warranty shall be limited to the repair

or rework of the goods supplied or replacement thereof, at Seller's option,

and in no case is to exceed the invoice value of said goods. Under no

circumstances will the seller be liable for incidental or consequential

damages or for damages incurred by the buyer or subsequent user in

repairing or replacing defective goods or if the goods covered by this

warranty are reworked or subjected to any type of additional processing.

This warranty is void if Seller is not notified in writing of any

rejections or defects within 1 year after the receipt of the material by the

customer.

THIS WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES

EXPRESSED OR IMPLIED, INCLUDING MERCHANTABILITY.

INSTALLATION INSTRUCTIONS USING 784740

ADAPTER FOR ATTACHING TO GB784 TOOL

cont.

3. Attach the pulling head to the adapter (784740).

4. After pulling head is attached, then back off pulling head until

hole in the adapter sleeve (60415) lines up with one of holes in

nose assembly adapter (784740).

5. Secure to tool using Soc. Hd. Cap Screws (401208) with lined up

hole. Secure second screw in secondary location.

Note: The shift point setting on the tool must be adjusted to

compensate for the longer stroke when using adapters.

6. Remove limit pins.

7. Turn adjusting knob counter-clockwise until it stops.

The GB784 will now install Cherrylock rivets up to 1/2" grip

length. Before using a straight 681 series pulling head again,

the tool must be re-adjusted using stroke setting gage (784159).

See GB784 tool manual for instructions.

WARRANTY

Adapter

(784740)

Adjuster Knob

Limit Pin

Rev. 3/18