Frigidaire WRT8G3EWC 사용 및 관리 매뉴얼 - 페이지 6
{카테고리_이름} Frigidaire WRT8G3EWC에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire WRT8G3EWC 18 페이지. Top mount refrigerator
페이지 인쇄
- 1. Table of Contents
- 2. Welcome
- 3. Safety Instructions
- 4. Removal & Reversal
- 5. Door Removal/Reversal
- 6. Features at a Glance
- 7. Temperature Controls
- 8. Looking Inside
- 9. Ice Service
- 10. Ice Service
- 11. Food Storage
- 12. Normal Operating Sounds
- 13. Care & Cleaning
- 14. Care & Cleaning
- 15. Warranty
- 16. Before You Call
DOOR REMOVAL / REVERSAL INSTRUCTIONS
DOOR REMOVAL AND REVERSAL INSTRUCTIONS:
N O T E
N O T E
N O T E
N O T E
N O T E
If you have stainless steel doors -- go to the Removing Stainless Steel Doors
and Handles Section on page 8.
The direction in which your refrigerator doors open (door swing) can be
reversed, from left to right or right to left, by moving the door hinges from one
side to the other. Reversing the door swing should be performed by a
qualified person.
IMPORTANT
Before you begin, turn the refrigerator temperature control to "0" and remove
the electrical power cord from the wall outlet. Remove any food from door
shelves.
1.
Remove toe grille.
2.
Remove top hinge with 3/8" hex driver and lift freezer door off of center
hinge pin. Set door aside.
3.
Unscrew center hinge pin using adjustable wrench and save for
reassembly. Ensure plastic washer stays on hinge pin.
4.
Lift refrigerator door off of bottom hinge and set aside.
5.
Remove center hinge and shim by removing inside screw and
loosening two outside screws enough to allow hinge and shim to slide out.
Tighten screws.
6.
Loosen two outside screws on opposite side of refrigerator, remove inside
screw and install center hinge.
7.
Remove two screws on bottom hinge with 3/8" socket wrench.
8.
Install bottom hinge on opposite side with the two screws removed from
step 7.
9.
Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to
other hole in hinge and tighten with adjustable wrench.
10. Reverse door handles (see instructions on next page).
11. Move freezer and refrigerator door stops to opposite side. Before starting
screws, use an awl to puncture the foam.
12. Position refrigerator door onto bottom hinge pin and screw center hinge pin
through center hinge into top of door. Close refrigerator door to help align
hinge hole.
13. Tighten center hinge pin with adjustable wrench.
14. Remove cabinet and hinge hole plugs and move to opposite side.
15. Lower freezer door onto center hinge pin.
16. Close freezer door. Have an assistant lift up on opposite side of door while
tightening screws to install top hinge.
17. Replace toe grille.
18. Plug in electrical power cord and turn refrigerator temperature control to
center position. Adjust setting as necessary.
6