Gage Bilt GB54B 원본 사용 설명서 - 페이지 7

{카테고리_이름} Gage Bilt GB54B에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB54B 16 페이지. Pneumatic installation tool
Gage Bilt GB54B에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

페이지 인쇄
Gage Bilt GB54B 원본 사용 설명서
When the actuator assembly (1) (510127) is depressed, the pressurized air inside the tool is directed to the front side of the piston
(3) (510101) thus moving it to the rear of the cylinder assembly (2) (500119), forcing the air from the back side of the piston (3)
(510101) to be exhausted from the standard exhaust port on side of tool (see page 5). The internal components of the attached nose
assembly are simultaneously moving with the piston (3) (510101) to start the fastener installation. When complete, the actuator
assembly (1) (510127) is released directing the air to the back side of the piston (3) (510101) reversing the sequence.
3
2
1
Piston in forward position
Air is exhausted through the standard exhaust port on the side of the tool. To redirect air exhaust to rear of tool, remove plug (401816)
from rear exhaust hole. If changing exhaust back to side, we recommend applying Vibra-tite® to plug (401816) before installation.
STANDARD
EXHAUST
(Side of tool)
OPTIONAL
EXHAUST
(Rear of tool)
GB54B S/N: 1088 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

PRINCIPLE OF OPERATION

3
2
1
AIR EXHAUST
Air is exhausted through
Standard Exhaust Port
on side of tool.
Air is exhausted through
Rear Exhaust Port
Images may not reflect actual tool
7
Piston in rear position
Rear Exhaust Port
Plugged
Rear Exhaust Port Plug
removed. Side port plugged.
Rev. 10/22