Gage Bilt GB703SRVT/4N6E 설치 매뉴얼 - 페이지 12

{카테고리_이름} Gage Bilt GB703SRVT/4N6E에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB703SRVT/4N6E 14 페이지.

HANDLE

To inspect air cylinder bore, remove base cover (704125). Any further disassembly will require removal of the manifold-handle (744303) first. For

complete disassembly, start by removing base cover (704125). Next, holding tool upright, remove four screws (A-928). Lift manifold-handle (744303)

from handle assy (704132) and set aside o'ring (S832) and gasket (704129). Empty all hydraulic oil into an approved container and dispose of in

accordance with all environmental regulations applicable in your area. Place piston rod wrench (704149) down into top of power cylinder (751131)

and into the hex of piston rod assy (704138). While holding this wrench, remove flexlock nut (400559) using a 7/16" socket wrench. Still holding pis-

ton rod wrench (704149), remove air piston assy (704121) using packing plug wrench (704150), by turning counterclockwise. When air piston assy

(704121) is completely free from piston rod assy (704138), tap or push on the piston rod wrench to eject air piston assy (704121) from bottom of

handle assy (704132). After removal of air piston assy (704121), slide piston rod assy (704138) back up to the end of its travel. Using packing plug

wrench (704150) remove packing plug (704118). With packing plug (704118) removed, power cylinder (751131) can be removed by pushing on pow-

er cylinder tool (704151) when inserted into top of power cylinder (751131).

To reassemble the handle assy (704132), reverse the above procedure, being certain that all o'rings are properly lubricated before installation.

Torque packing plug (704118) to 45 foot lbs. Attach the seal guide (704152) to the piston rod assy (704138) and tap the piston rod assy (704138)

through the packing plug (704118). Attach air piston assy (704121) and flexlock nut (400559). Torque flexlock nut to 40 inch lbs. Attach air piston

assy (704121) to piston rod assy (704138). With the piston rod assy (704138) in the down position, fill oil passage on top of handle assy (704132)

with automatic transmission oil, Dexron III or equivalent. When looking at top of handle assy (704132), the oil passage is the hole that has a counter-

bore for (S832) o'ring. Replace gasket (704129) and o'ring (S832), just prior to replacing manifold-handle (744303). (See Filling & Bleed-

ing instructions.)

AIR VALVE

WARNING

Disconnect tool from its air source before disassembly.

To disassemble, first disconnect tool from its air source. Remove pin (704244) and muffler (704146). Insert valve extractor (S1178)

into end of valve plug (704145) and pull it out. Using the same procedure, pull out valve spool assy (703142). NOTE: It should never

be necessary to remove valve sleeve (703139) unless the ports in the valve sleeve (703139) are plugged from contaminated air. If

ports are plugged, use needle nose pliers to grasp end of spring (704141), turning clockwise and pulling to dislodge from groove in

casting. NOTE: Valve spring tool (704162) will facilitate the proper installation of the spring (704141), valve sleeve (703139) can be

pulled out using valve sleeve removal tool (704163).

11/14