Gage Bilt GB704 설치 매뉴얼 - 페이지 5

{카테고리_이름} Gage Bilt GB704에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB704 13 페이지. Installation tool
Gage Bilt GB704에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지), 원본 사용 설명서 (20 페이지)

페이지 인쇄

HOW TO USE THE GB704

WARNING:

Operator

WARNING:

It is required that eye protection and hearing protection be worn during operation.

WARNING:

Do not pull rivet in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from the bottom of the too. Direct bottom of the tool (exhausted air) away from

operator, other persons working in the vicinity, foreign matter and liquid.

CAUTION:

Do not use beyond the design intent.

The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept

end-user air hose fitting. The tool comes with oil and is ready to use.

1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.

2. Attach Deflector (200232) to rear of Head Cylinder Assy (704108).

WARNING:

Rotate deflector away from operator and other persons working in the vicinity.

3. Connect air hose with 90 psi. (6.2 bar) to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. (6.2 bar) is

recommended) and cycle tool a few times by depressing and releasing actuator lever assy (704343). (Clean dry air is

mandatory).

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

4. Disconnect air hose from tool.

5. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for

further instructions.)

6. Connect air supply.

7. Insert rivet into Nose Assembly and the application then depress actuator lever assy (704343). Upon releasing the

actuator lever assy (704343), the stem will eject to the rear of the tool.

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

GB704 S/N: 3213 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

read and understand all warnings and cautions.

Image may not reflect

actual tool.

6/11 Rev. 9/14