Gage Bilt GB708LGP 설치 매뉴얼 - 페이지 5

{카테고리_이름} Gage Bilt GB708LGP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB708LGP 8 페이지. Hydraulic tool

페이지 인쇄

DESCRIPTION

The GB708LGP hydraulic installation tools designed specifically for the efficient installation of 1/4"

LGP® lockbolts. It weighs just over 3 lbs. (1.36 kg) and can be operated in any position with one

hand. It has a .500 (12.7mm) rivet setting stroke and a rated pull load of 5800 lbs. (25.8 kN).

The GB708LGP installation tool operates on hydraulic pressure developed by the GB940 Powerunit

set at 5600 psi (386.1 bar) maximum PULL pressure and 2400 psi (165.5 bar) maximum RETURN

pressure. The tool comes equipped with 12 feet of hydraulic hoses (206119), hydraulic coupling-

male (585047), hydraulic coupling-female (585038), electric actuator (240122) and electric cord

(206136).

MAINTENANCE

WARNING:

Excessive contact with hydraulic oil and lubricants should be avoided.

WARNING:

Maintenance personnel

WARNING:

Be sure powerunit is disconnected before cleaning or when replacing worn or damaged

components. Severe personal injury may occur if power source is not disconnected.

The performance of any tool depends upon the practice of good maintenance.

Following these minimal requirements for service and care will extend the life of your tool.

*Only use a hydraulic power source equipped with relief valves and pressures set within

specified limits.

Consult Powerunit Manual for procedure to set Pull and Return pressures.

*Keep hydraulic system free of dirt. Avoid letting couplers contact a dirty floor.

*Proper care by operators is necessary in maintaining full productivity and reducing down

time.

*Check tool, all hoses and all couplings daily for damage or air/hydraulic leaks. Tighten or

replace (if necessary).

*To replace super-grip jaw ass

1. Remove cap (705112) from back of piston ass=y (708116).

2. Remove spacer (48812) and old super-grip jaw ass=y (30861-S1).

3. Insert new super-grip jaw ass=y (30861-S1) and spacer (48812).

4. Apply removable Loctite7 to the threads of cap (705112).

5. Thread cap (705112) approximately 3/4 into back of piston ass=y (708116).

6. Insert spent pintail into super-grip jaw ass=y (30861-S1) and continue threading cap

(705112) until spent pintail ratchets through super-grip jaw ass=y (30861-S1).

7. Let Loctite setup.

HYDRAULIC THREAD PREPARATION

IMPORTANT:

Be sure to use thread sealant on all hydraulic fittings, Loctite® 30534 or similar Teflon® infused pipe

dope is recommended.

applied, pieces may enter the hydraulic system and cause malfunction and damage. Use 1 1/2 wraps

of tape on each thread. Cut off all loose tape ends. Tighten until fitting feels snug and then go 1/2 to a

full turn past that point.

S/N: 1107 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

read and understand all warnings and cautions.

y (30861-S1):

CAUTION:

Teflon tape is an excellent thread sealer, however, if not properly

CAUTION:

Over tightening can easily distort the threads.

REV. 7/14