Gage Bilt GB722 원본 사용 설명서 - 페이지 7
{카테고리_이름} Gage Bilt GB722에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB722 20 페이지. Installation tool
Gage Bilt GB722에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 원본 사용 설명서 (20 페이지)
페이지 인쇄
When the actuator lever assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the
valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward
direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool.
Simultaneously, the piston rod assembly connected to the air piston assembly is also moving down, forcing hydraulic oil up and into
the front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly. The internal components
of the attached nose assembly are also moving with the piston to start the fastener installation. When the fastener installation is
completed, the actuator lever assembly is released. Air pressure is then built up inside of the handle causing the valve spool assembly
to return to its original position and reversing the sequence directing air pressure to the rear of the head cylinder assembly, causing
the piston to move to the forward position.
PULL Cycle
Air exhaust
Piston Rod Assembly
moves down
Air Piston
moves down
GB722 S/N: 1753 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
PRINCIPLE OF OPERATION
Piston Rod Assembly
moves up
Air Piston
moves up
Air exhaust
Pressurized Oil
Pressurized Air
Unpressurized Oil
Unpressurized Air
Images may not reflect actual tool
7
RETURN Cycle
Air exhaust
REV. 5/22